Rail Kit Installation Manual RS100 Series E12611 / First Edition / March 2017..
Rail Kit Installation Manual 2 1. Rail kit installation 1.1 Rackmount rail kit items The rackmount rail kit contains two pairs of rails (one pair for each side of the server system), six (6) pieces of inner rail screws, and two (2) pieces of rack screws. Inner rail screws Rack screws Outer rails Inner rails 1.2 Attaching the rails to the rack To attach the rack rails: 1. Attach the inner rail to the correspoding side of the chassis and secure with three inner rail screws. Make sure the rail is oriented as shown...
Rail Kit Installation Manual 3 2. Attach the second inner rail to the other side of the chassis and secure with three inner rail screws. 3. Select one unit of space (1U) on the rack where you wish to install the server. 4. Place three (3) nuts on the front and three at the back. Do the same to the corresponding side of the rack. Nuts 5. Adjust the length of the outer rail to ﬁt the length of the rack cabinet, then fasten the two screws. 6. Secure the outer rail with two screws at the front and rear of the rack cabinet. 7. Find the corresponding 1U space on the other side of the rack cabin..
Rail Kit Installation Manual 4 8. Firmly hold the server on both sides. Slide the latches on the inner rack rails to the direction indicated below. Hold the latches, and insert the rear side of the server to the front end of the outer rack rail. Make sure that the inner rails are properly aligned with the outer rails...
Rail Kit Installation Manual 5 10. Secure the server to the rack with one rack screw at one side. Secure the other side as well. 9. Carefully push the server all the way to the back until the front panel ﬁts the front end of the rack. Rack screw..
Rail Kit Installation Manual 6 2. Rail kit dimensions TRAVEL=451.5±4mm RAIL LENGHT=660.5mm 20.5mm 693mm..